Syrup Rotor Pump Mechanical Seal 106-20mm 25mm 30mm 35mm 40mm

Single Mechanical Seals to suit SRU (SSP SR) & NMOG Range.
Double Mechanical Seal version available as W03DU.

Most commonly used on twin lobe pumps found extensively in Food Process, Dairy and Brewery Industries. Available in Food Grade materials as standard (with FDA compliant materials).

• AESSEAL Mechanical Seal alternative to:
  • John Crane 87 (EI/ EC) seal
  • Roplan RTH87/ R90 seal
  • Sterling 280W/ 282 seal

The following pictures are for inoxpa pump seals.
mechanical seal the ROTATING PART15 SILICIO/EPDM 35
1G330-4050035 4G15-47.35 -105078
mechanical seal theSTATIONARY PART B15 GRAF/EPDM 35 1G322-1050035, 105081
4GB151-7.35

Preperation:
1. Shaft Outside Diameter is within tolerance +-0.05mm
2. Shaft run out <0.1mm
3. Shaf end float <0.13mm
4, No sharp edges on the shaft over the o ring

Note:
During the installation,don't scratch or damage the o ring.lf anything is damaged,please contactwith Us to replace a new one.

Installation in strucstions:
1. The full set of cartridge seal is cleaned and exactly passed leakage examine before sale.Inorder to avoid damage,don't disassemble and clean the parts again before fixing.

2 The fitting allowance between the seal and shaft is dl h6 0.8,and there should be leading-inedge at the end of shaft.The outside diameter of shaft at the position of screw should be 01 0.2mm smaller,resisting the screw over-tighten.Lubricate the shaft with oil

3. Place the cartridge seal into the pump chamber,then:
A: Tighter four screw bolts of flanges,ensuring the medium leading in hole"G"at the top Position

B : Tighter four set screws and position the shaft sleeve on the shaft.
C: Remove four gauge plates.Please keep them and they wil be used in future installation and
disassemble.
D: Connect the medium lead_in pipe with hole"G"in order to flush away the friction heat and
flushing the seal chamber when pump running.

Note:
ter complete the installation,turning the shaft by hand to check for the rotationi he shat could not rotate smoothily,seal had been improperly installed.

We would like lo sincerely ooperale with Clients to supply high qually products and senice We beleve in establishing a long:erm cooperalive relalionshipis lhe key to suceess